MyCalCute
Install
Calculators / Construction / Evenly spaced holes

Evenly spaced holes calculator

Lay out hole centres at equal intervals with both endpoints included.

On this page

Your result

Number of holes including ends7
Equal spacing166.67mm
Number of gaps6

Calculator controls

How to calculate

Evenly spaced holesEvenly spaced holesEvenly spaced holesA span of 1000 mm with a maximum 180 mm gap needs six gaps and seven holes. Concept diagram; not to scale.Evenly spaced holesDistance betweenfirst and last…1000Maximum centrespacing (mm)180Number of holesincluding ends7MyCalCute.comDistance between first and…1000Maximum centre spacing (mm)180Number of holes including…7
Evenly spaced holesA span of 1000 mm with a maximum 180 mm gap needs six gaps and seven holes. Concept diagram; not to scale.Evenly spaced holesDistance betweenfirst and last…1000Maximum centrespacing (mm)180Number of holesincluding ends7MyCalCute.com
A span of 1000 mm with a maximum 180 mm gap needs six gaps and seven holes. Concept diagram; not to scale.

Lay out hole centres at equal intervals with both endpoints included.

Number of holes including ends = ceil(span/spacing)+1
Equal spacing = span/ceil(span/spacing) mm
Number of gaps = ceil(span/spacing)

Worked example

  • Distance between first and last hole centres (mm): 1000
  • Maximum centre spacing (mm): 180
  • Number of holes including ends: 7
  • Equal spacing: 166.67 mm
  • Number of gaps: 6

Assumptions and limits

Measure between the desired end centres after accounting for edge margins. The calculation covers layout geometry and does not establish structural fastener spacing.

Results are rounded for display; calculations use unrounded values. Read our calculation methodology.

Understanding the result

Lay out hole centres at equal intervals with both endpoints included. A span of 1000 mm with a maximum 180 mm gap needs six gaps and seven holes.

When this tool is useful

A span of 1000 mm with a maximum 180 mm gap needs six gaps and seven holes.

Understanding your inputs

InputExample
Distance between first and last hole centres (mm) span1000
Maximum centre spacing (mm) spacing180

Frequently asked questions

Which assumptions apply?

Measure between the desired end centres after accounting for edge margins. The calculation covers layout geometry and does not establish structural fastener spacing.

How can I verify the result?

Use the values in the worked example and keep consistent units throughout the calculation.