MyCalCute
Install
Calculators / Construction / Rectangular border area

Rectangular border area calculator

Find the area of a uniform border around a rectangular patio or garden.

On this page

Your result

Border area11m²
Outside area35m²

Calculator controls

How to calculate

Rectangular border areaRectangular border areaRectangular border areaA 4 by 6 metre rectangle with a 0.5 metre border has 11 square metres of border. Concept diagram; not to scale.Rectangular border areaInner width (m)4Inner length (m)6Border area11 m²MyCalCute.comInner width (m)4Inner length (m)6Border area11 m²
Rectangular border areaA 4 by 6 metre rectangle with a 0.5 metre border has 11 square metres of border. Concept diagram; not to scale.Rectangular border areaInner width (m)4Inner length (m)6Border area11 m²MyCalCute.com
A 4 by 6 metre rectangle with a 0.5 metre border has 11 square metres of border. Concept diagram; not to scale.

Find the area of a uniform border around a rectangular patio or garden.

Border area = 2*border*(width+length)+4*border^2 m²
Outside area = (width+2*border)*(length+2*border) m²

Worked example

  • Inner width (m): 4
  • Inner length (m): 6
  • Border width (m): 0.5
  • Border area: 11 m²
  • Outside area: 35 m²

Assumptions and limits

The border is outside the inner rectangle and includes four square corners. Add your own allowance for cuts and waste.

Results are rounded for display; calculations use unrounded values. Read our calculation methodology.

Understanding the result

Find the area of a uniform border around a rectangular patio or garden. A 4 by 6 metre rectangle with a 0.5 metre border has 11 square metres of border.

When this tool is useful

A 4 by 6 metre rectangle with a 0.5 metre border has 11 square metres of border.

Understanding your inputs

InputExample
Inner width (m) width4
Inner length (m) length6
Border width (m) border0.5

Frequently asked questions

Which assumptions apply?

The border is outside the inner rectangle and includes four square corners. Add your own allowance for cuts and waste.

How can I verify the result?

Use the values in the worked example and keep consistent units throughout the calculation.